Or a TM250
https://motocrossactionmag.com/mxa-r...%20carburetor.
Sorry. I got all excited.
Don't you look at my accountant.
He's the only one I've got.
Perhaps tomorrow? RD always takes longer.
Actually I had a little trouble tracking down the AG. Loaned to a guy who loaned to a guy, you know how it goes.
Found, in Rotorua, be back by the end of the week. Apparently it makes for a good hunting bike. Wont be good for that by the time Im finished with it, Deer will be long gone.
Thankyou.
Doubt it? More like 24 days.
So if i have a 250 villers starmaker powered Kx250
the chassis is essentially same as pre 70 so it can run vintage with its 250 four speed. Interesting.
intake rubber
https://www.trademe.co.nz/a/motors/m...ing/3709597560
rip off v force reed valve
https://www.trademe.co.nz/a/motors/m...ing/3701507704
Kinky is using a feather. Perverted is using the whole chicken
Mk 3, or 4? Can't remember exactly now. Its still there under the bench, somewhere. Cut down Wade supercharger off a Commer Diesel, TS3.
While we're on the subject of the legendary Tf125 how much fork oil do they hold of what grade and if keeping the oil pump on it how do you bleed and set it up ?
6 inches from the top and add some if not enough is a rule of thumb, (that I've heard and never tried).
Check my thread Pete's TF. Too long ago to remember but the left main could, or should have a hole from the transfer to main. Right could have seal so bearing is on gearbox side . But can't remember accurately. If there wasn't you need to make a hole to match one on the left. The T125 had all sorts of other shielding and feed holes, the RG was simple and fukd if I can remember which was which. Poxy Suzukis. You'd think I'd be a fan.
Otherwise open the bleed screw on the pump till it runs easily. It should then progress up to the barrel feed. Run it on premix until you are sure it is getting there with no bubbles. If there are two lines, one will be to barrel and one to a main and there will be check valves.
Don't you look at my accountant.
He's the only one I've got.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks