Pod filter

[Bonez]

I considered that too, Bonez. I'll go and see them tomorrow lunchtime.
Did the GB run any differently ie. jetting ?

Runs sweet as a nut. Haven't had to change a thing. Guess I was lucky

[DEATH_INC.]

There's a lot of stories running around regarding pod filters,some accurate some not.Genenral consensus is they don't work well on modern down draught carb/injected bikes(with a couple of exceptions),but can work well on older style jobbies IF SET UP PROPERLY!!! This is where a lot of the bs about 'em loosing power came from, if you don't have the skilz to rejet properly(and they can be bloody tricky to get right) they often don't work well as they lean it out lots costing much HP. If you got the time and patience it'll work just fine.

[F5 Dave]

Is there anywhere in Welly that I can purchase filter foam?
The nearest Para Rubber is in Palmy North.

Boyles should have/will be able to get the Uniflow sheet foam. Richards in J'ville have had it in the past too.