building a wiring loom

[Buddha#81:Me]

hey Ivan, its just a homemade megaphone. No i wont be coming to Manfeild next year if you read my profile im married with two boys thats why I race a bucket. I'll will be going to the Nelson Street races on the 2nd Jan, there sould be a good bucket turn out, hope some of you north island poofta's are comming down.

[Ivan]

it a manfield bucket round only but o well

[Ivan]

Well I am going to go align the chain on the bike if I get a chance weld the mounts some stage get some pipe for the exhaust figure out an exhaust system and all that will be holding me back is the engine mounts when I make mounts I will take motor out and add the performance mods chuck it back in and be heading up to Manfield with it,

Hey Spud what ya using for a frame

[Ivan]

here are the pics camera is shite


pic 1 is CDI wires if you cant see em properly I will tell you what they are

Pic 2 Cam Wire? I think?

Pic 3 Stator wires


the others are it just mounted in frame bar it not being welded:slap:

[Buddha#81:Me]

The blue and the green wires on pic 1 that are close together go to the cdi pick up on the end of the cam shaft.

There will be a black with white stripe that is your low tension feed to the spade terminal on the back of your coil.

Black with red stripe goes to the stator on the end of the crank (this my be the problem i think you may have a points motor).

Good luck, its bloody hard when you know what to do and trying to explain
how to is a chalenge.

[Ivan]

ah fuck I dont understand that either man I think it as a poo poo

[Ivan]

it is a cdi motor tho

[Ivan]

can anyone figure this out

[gav]

Is the motor an ex race one? Has it been in a bucket? Seems to have alot of wires there...

[Ivan]

ok motor I got from my mate Nathan and CDI I got from my mate Luke and coil came from RG100!! so it all there motor was never a bucket I dont think but was going to be and now will be

[Sketchy_Racer]

are you sure the CDI is the correct one for this bike??

[Ivan]

yep sure am