Hardcore Biker
Its xmas, im up visiting my folks and find dads got a killer mig welder sitting in his shed begging me to make a paddock stand for my RF900. Problem is that we took the car up and I cant find the specs on the net for the outside width of the swingarm or its height off the deck where the pit stand nuts are supposed to be mounted. Can anyone help?
on the up
Just measured mine.
Allow about 310mm minimum for swingarm width.
Height from ground to center of swingarm bobbin hole on mine is 285mm.
And I to my motorcycle parked like the soul of the junkyard. Restored, a bicycle fleshed with power, and tore off. Up Highway 106 continually drunk on the wind in my mouth. Wringing the handlebar for speed, wild to be wreckage forever.
- James Dickey, Cherrylog Road.
Hardcore Biker
Thanks!!!!!!!! Shall I make 2 or do you already have one? (that is if I can get enough steel)
on the up
Cheers Timber.
Got one already.
And I to my motorcycle parked like the soul of the junkyard. Restored, a bicycle fleshed with power, and tore off. Up Highway 106 continually drunk on the wind in my mouth. Wringing the handlebar for speed, wild to be wreckage forever.
- James Dickey, Cherrylog Road.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks