Prefer aircooled if possible, consider engine only, anything out there?
Prefer aircooled if possible, consider engine only, anything out there?
i hope your not gonna use it in buckets?? cause thats cheating you know :duh:
Yeah, I know the rules, thanks for your concern![]()
i dont think people would be worried if gav even showed up on a 125 gp bike.Originally Posted by RG100!!
![]()
Hmmm, lend me yours and we'll find out, eh?Originally Posted by k14
Originally Posted by k14
I know I wouldn't be, the power to weight ratio would still be worse than my bucket![]()
As far as I'm concerned using a FXR is cheating aswell, and even worse is the cheats that are putting hoted up bit into them.Originally Posted by RG100!!
If its a FXR in a home built or differant frame then thats not so bad.... Gav use the CR if ya want..... and ummmmm I reckon if you were on K14's 125RS at least you would finish the race
BTW I know the FXR is legal to use, I'm just pissed cos I'll never beat one
cheers DD
(Definately Dodgy)
LOL...
yea to be honest,
i think the old aircooled 80cc MX bike engines should be fine for buckets......
And i know that the FXRs are "to flash" for buckets......
Get fucked you jealous prick, the rules allow themOriginally Posted by dangerous
I'll tell Stanko you called him a cheat he'll be round to sort you out![]()
I might be a jealous prick.... but at least I'm not a grumpy, old, sour, aint getting any kinda bastardOriginally Posted by Kickaha
yeah take that Kickaha....... Oh BTW I'm not worried about your new bucket it wont go long enuff to kick my arse..... its the others I have a problem with
![]()
cheers DD
(Definately Dodgy)
Yeah, so who's going to be the first to fit a FXR motor in a RS125 rolling chassis (apart from Ivan) ?
Ivan will do it.........
with sticky tape and glue....
But i dont think it would be possible to fit it in. Physics say it cannot be done.
Originally Posted by gav
I will 10 characters
Blindspott are back as Blacklist check them out
www.blacklistmusicnz.co.nz
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks