RD350LC Barrels & Head (please)

[Arronduke]

Come on guy and girls there has to be some one who will sell a set of barrels and a head for a RD350LC.

Some one must have a set to sell to a super nice guy who is building a LC for the road.

Please Please Please
029 2615130

[stanko]

have you tried city motorcycle wreckers in auck?

[Arronduke]

Yes I have and I am hoping City Motorcycles will help me out. So far they have been great with other bits so here hoping.

They have a huge stock of parts and are great to deal with.
Recommended.

[geoffm]

Tried e-bay - especially the UK oen? I got a set of Taymar stage 3 barrels off ebay -still waiting to get-around-to it and some $$ for new pistons. Also try the RD forum.
Don't forget to trim teh tang if you are using RZ/ Banshee pistons
Geoff

[Turtle]

Tried e-bay - especially the UK oen? I got a set of Taymar stage 3 barrels off ebay -still waiting to get-around-to it and some $$ for new pistons. Also try the RD forum.
Don't forget to trim teh tang if you are using RZ/ Banshee pistons
Geoff

RD forum????? y dont I know about this...
And while on the subject of wanting 350LC bits ..would be happy if someone wanted to sell me a good crank.
As far as the head and barrells go grab a motorcycle marketplace mag...there are still a few guys wreking these...(shame on them).

[stanko]

RD forums
http://www.yamaha-rd.com/forum/
http://www.rzrd500.com/phpBB2/
the second one is for RZ350

You can buy a new crank center from Prox engineering in UK

[geoffm]

RD Forum:
http://www.yamaha-rd.com/forum/
There is Norbo's LC Crazy board at http://rdlccrazy.proboards59.com/index.cgi?
Norbo is a good buy to deal with - I got some parts from him recently
www.rdlccrazy.co.uk

As far as getting a crank, forget it. Get your current one rebuilt, or modify a YPVS (RZ/ Banshee) crank. The YPVS has 1mm wider bigends than the LC, so you need to shorten the centre pins by 1mm. The end webs are the same. Pro-x make
replacement RZ/Banshee end webs.
Geoff