Wiring problem - Honda

[surfer]

Fuses are all good. Its always first port of call. Indicator relays dont even go. It cant be the main fuse either as the bike runs and everything.

Damn electrics. Anyone want a go at it?

Try looking for a broken wire or a bad connection.

When you checked your fuses did you inspect them really carefully, also were they able to connect with the pads at both ends inside the connection? Sometimes if a fuse blows it will generate enough heat that the pads inside the connector will melt into the plastic (if you have this type of fuse holder on your bike) and thus prevent the current from flowing.

[Morcs]

Try looking for a broken wire or a bad connection.

When you checked your fuses did you inspect them really carefully, also were they able to connect with the pads at both ends inside the connection? Sometimes if a fuse blows it will generate enough heat that the pads inside the connector will melt into the plastic (if you have this type of fuse holder on your bike) and thus prevent the current from flowing.

mmm good point, ill replace all the fuses (i have heaps )

I fixed the indicators, just no dip lights now...

[johnnyflash]

Sorry, arriving a bit late in this thread,(so appologies if Im off beam) but I assume from the posts that the fuse only blows when you turn on the left indicator, and only under that scenario, if so then the short is only in the left indicator circuit, in which case you may be able to disconnect the wire going to lamp and trace that back to find fault, also check bulb housing where wiring enters... then trace back to flasher unit.