Yoshimura carbon pipe and tyres

**dmc** · 28th April 2007, 18:09

Yoshimura Titan Carbon slip on pipe off TLR but can be fitted to other bikes,
Bought but now not needed so just taking up room in the garage, priced to go at $350.00,

2x Pair of tyres group lot,
1x pair Mitas E-07's 130/80/17 rear 90/90/21 front
1x pair Bridgestone Trailwings 140/80/17 rear 90/90/21 front
Open to any reasonable offer, replaced the Mitas with some E-09 when I purchased the bike but found them to be very good on the one ride I did with them, can't comment on the Bridgestones.

Prefer tyres picked up as hard to ship, can be viewed most anytime if wanted.

**JimO** · 28th April 2007, 19:40

only the one can??

**johnsv650** · 28th April 2007, 19:55

on the can what size is the pipe at joining point?

**dmc** · 28th April 2007, 20:00

Yes only one, the previous owner had a single sided exhaust (right side) on his TLR I believe, it was only used for a short period of time and then replaced with something else.

I was told it is over $1000 retail when new, was going to use on my bike but then got a bolt on Arrow pipe so no longer needed.

**dmc** · 28th April 2007, 20:02

Inlet is 2-1/2 inch.

**WarlockNZ** · 28th April 2007, 20:04

Would the can fit my Hobag?? ... LOL

**dmc** · 28th April 2007, 20:09

Originally Posted by WarlockNZ

Would the can fit my Hobag?? ... LOL

I'm sure you could make it fit but reckon it would probably be over kill for a 250cc since it was for a 1000cc

**WarlockNZ** · 28th April 2007, 20:10

Originally Posted by dmc

I'm sure you could make it fit but reckon it would probably be over kill for a 250cc since it was for a 1000cc

Your probably right ... hmmm ... think of the sound ... HA HA ... damn it ... where's my drill ??

**johnsv650** · 28th April 2007, 20:15

warlock get hyosung 650 then it would fit

**WarlockNZ** · 28th April 2007, 20:23

Originally Posted by johnsv650

warlock get hyosung 650 then it would fit

Hmmmmm ... nah ... you can get so much more bike for the same money

**johnsv650** · 28th April 2007, 20:39

ono on pipe?

**dmc** · 28th April 2007, 20:54

Originally Posted by johnsv650

ono on pipe?

Not at the moment as I recon its already a pretty sharp price, I'm waiting to hear back from someone else but if it doesn't go in the next couple of weeks I may move a little.

I'm in Kaiapoi and have PM'd you my number if you want to come have a look tomorrow.