F5’s first ever brand new bike!

[F5 Dave]

Might get lucky with a foulstroke airbox with offset. . Maybe.

[jasonu]

Dave there are rubber plumbing connectors that might work for you. I used one when I fitted a mikuni to my Maico490. Cheap and works.

[F5 Dave]

Well have to go to mitre10 at some stage, might hit the plumbing section for ideas. The airbox is as wide as it can be and still fit the frame but now the carbs are 10mm further apart due to 5mm less offset each.

[F5 Dave]

So my plan B was CB900 airbox rubbers, the outer ones have a decent gooseneck. They trade for a hundred clangers for a good set. I'd pay that to get out of this mess.

Sadly turns out they are only like 55mm where the carbs are 60. Buggeration.

I think that's it for this summers aspirations.

[husaberg]

So my plan B was CB900 airbox rubbers, the outer ones have a decent gooseneck. They trade for a hundred clangers for a good set. I'd pay that to get out of this mess.

Sadly turns out they are only like 55mm where the carbs are 60. Buggeration.

I think that's it for this summers aspirations.

I know a few sites that do rubber inlets and outlets. i will have a look.
ere you go you might as well stay with the Honda theme.
https://shop.eshifterkart.com/Intake...CR125-0364.htm
If you go to your local kart shop they likely have the joiners for the Kart pods that they use same as these.
https://www.rightkarts.co.nz/products/view/30421

https://www.claussstudios.com/store/c39/Suzuki.html
http://www.vmxunlimited.com/air-boot...rb-to-air-box/

[F5 Dave]

$80 worth of Will this work?

Well, maybe. Airbox cutting time.