Dirt bike ride was close and short loop so got home early. Started off foggy and cleared up mint.
Check this photo out. I always carry a tripod and SLR. I can post shutter speed for those interested.
Nah just my cell phone but look at it. I told Pete to hide his face.
Don't you look at my accountant.
He's the only one I've got.
Anyhoo Decided to flag shopping for new runners and try figure out the 500
Plugged it in to the laptop and revved it. Quickshifter goes Yes No Yes No. Ahhh.
Don't you look at my accountant.
He's the only one I've got.
Turned it (shift kill) off and went for ride. Problem solved.
Feels weak on part throttle . Needle position isn't right. Great when you open throttle. Went onto motorway and gave it a fat. Words like: Oh My. And Golly! were used.
. Riding position is like being home again.
Temperature is a concern though. 67 on motorway. That's fine I'm not looking for peak power. But got up to 89 following a slow coach up my hill.
It's not hurting it but not much leeway. I'll need to take it out Wairarapa where I intend to use it at a mixture of looping along, tight and flat out bits.
Don't you look at my accountant.
He's the only one I've got.
It's 6 o'clock and the sun is still savage . Dipping feet in paddling pool. Drinking local drop of brown fizzy water
Life is surprisingly good.
Don't you look at my accountant.
He's the only one I've got.
Rain all day cicadias still wont shut up. 16ft pool full of leaves
I see though a NC30 lower rad isnt going to work though.
https://www.kiwibiker.co.nz/forums/a...3&d=1204769894
Yeah it's tight. Small bikes 100hp.
Don't you look at my accountant.
He's the only one I've got.
https://www.kiwibiker.co.nz/forums/a...3&d=1204769894
https://www.kiwibiker.co.nz/forums/a...6&d=1207525745
looks like you can go up a little down a little plus a bit thicker and maybe widder with a curved one.
Then there the radiator to consider
i only just noticed the braced frame rails
here is a TL1000R dimensions but still looks no deeper or taller
Have a cardboard thicker template similar to Sketchy NSR300 Chinese rad.
Don't you look at my accountant.
He's the only one I've got.
Shame the lower NC30 wouldn't fit
https://www.trademe.co.nz/motors/mot...a39870cfa94c99
Price of a few Beers
This would not help the rad being to small but it might delay the result
http://www.factorypro.com/tech/radia...0pressure.html
Jason could acquire the spring for you
And ironically where I sourced the ZX radiator as we had a couple of beers. Maybe I should pop around and see what else might be on offer. Curved ones didn't seem to offer up well. Thicker Chinese one might be the go.
Still smarting over ripped inlet manifolds halting further progress. Had considered taking it to a local bike show as a work in progress. Look very unlikely for 2 weeks time.
Don't you look at my accountant.
He's the only one I've got.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks