Hyosung GT250R failed WOF - Headlamp :o(

[Stromble]

Hi Guys,

Not sure if you can help, but my GT250R failed its WOF on the full beam being too low..??!?, any one know how to adjust this? seems pretty high to me compared to the dipped.. but obviously not good enough for the WOF center..

[kiwi cowboy]

Hi Guys,

Not sure if you can help, but my GT250R failed its WOF on the full beam being too low..??!?, any one know how to adjust this? seems pretty high to me compared to the dipped.. but obviously not good enough for the WOF center..

have a good look round the headlight and mounting brackets there should be a screw to alter the vertical and one to alter left\right good luck

[98tls]

Hi Guys,

Not sure if you can help, but my GT250R failed its WOF on the full beam being too low..??!?, any one know how to adjust this? seems pretty high to me compared to the dipped.. but obviously not good enough for the WOF center..

Seems crazy to me.........by low do you mean the height or bulb strength ? either way for me anyway i never bother getting a WOF from anywere but a bike shop as if its simple like this they just fix it..with no charge.

[Pancakes]

If your near Whenupai we could meet up and check it out. The adjusters are there once your in the fairing. Shoulda got the nekkid one eh! I just ride along and get it right then tighten the bolts up more at home (save a few g's too). Bang on!

[Guided_monkey]

Where did you go for the WoF. I was at Westgate Onroad the other day and they were willing to adjust the headlight on a GSXR while they were testing.

It's a bit hard to be able to guess/estimate the correct height withput the correct equipment.

When you go back take the necessary tools in your pocket and adjust when you're with them. If they complain they're just being difficult.

[Stromble]

Yeh, seemed crazy to me that they wouldnt at least try to adjust, it was some drive thru WoF place off Archers road in Glenfield, I thought it may have failed on the exhaust as its been de-baffled and is VERY loud.. so not too bad, but its a pain in the ass to have to get adjusted and go back again. I think Ill have to take the fairing off as suggested and try and adjust at the re-test so it meets requirements.

I take the point about getting a WoF at a bike shop as they ca do the work there and then! Ill know for next time eh! Thanks for your help guys.

[sAsLEX]

Yeh, seemed crazy to me that they wouldnt at least try to adjust, it was some drive thru WoF place off Archers road in Glenfield, I thought it may have failed on the exhaust as its been de-baffled and is VERY loud.. so not too bad, but its a pain in the ass to have to get adjusted and go back again. I think Ill have to take the fairing off as suggested and try and adjust at the re-test so it meets requirements.

I take the point about getting a WoF at a bike shop as they ca do the work there and then! Ill know for next time eh! Thanks for your help guys.

hmm I go there I took a screwdriver and he showed me what lines I needed to adjust it to on the wall and left me to it, came back with the WOF when I had it sorted.

Must of got some guy in a bad mood