Rear Disc brake for CB650C

[rustycharm]

Any one know of a rear wheel set up including disc rotor that will fit a CB650C Swingarm without too much major modificaiton?

[What?]

What size is the standard wheel?
If it is 18", a CB750FC wheel will probably fit straight in (I just happen to have one hanging in my shed).
But if it is 16", you may have a problem...

[Bonez]

Any one know of a rear wheel set up including disc rotor that will fit a CB650C Swingarm without too much major modificaiton?

You may be able to adapt a CB750FB rear swing arm, disk, wheel etc They have same black reverse comstar wheels so wont look out of place. It's an 18" rear wheel but should fit with some effort.

[rustycharm]

Original was a 16 inch but I'll have a look at the CB750F option as its a complete unit that should be able to be modified with a bit of jiggery pokery

[rustycharm]

What size is the standard wheel?
If it is 18", a CB750FC wheel will probably fit straight in (I just happen to have one hanging in my shed).
But if it is 16", you may have a problem...

no swing arm hanging next to it?

[What?]

no swing arm hanging next to it?

'fraid not, but the wheel is yours if you want it. It's a gold one, though, not black. Has axle, tensioners, spacers, cush drive and brake disc.

[rustycharm]

Thanks for that ... will just do a bit of research on the possibility of the swing arm with the 18inch wheel before I add to the pile of bits in the garage.

[Bonez]

The distance between swingarm endcaps is a tad over 10 inches wide.