Lubes? (hehe)

**AllanB** · 27th December 2007, 17:33

For your number twos (tee he he) if you do not have any grease just smear some chain oil inside that hole, or a bit of CRC or WD40. Even a dab of vaseline in that hole should do the trick

However if it has a bearing that goes in there you only want enough lube to help tap the bearing in as it is the central part of the bearing that moves and the outside should not rotate in that alloy foot peg holder bit.

The paint looks good, how much did that selection of parts cost if you don't mind?

**placidfemme** · 28th December 2007, 06:35

Originally Posted by MSTRS

They only have to be air tight which the hose clamps should see to, though it might help when fitting the cabs to the rubber boots??

hmm... Not too sure what you mean... I'll have a look tonight...

thank again

**placidfemme** · 28th December 2007, 06:36

Originally Posted by AllanB

For your number twos (tee he he) if you do not have any grease just smear some chain oil inside that hole, or a bit of CRC or WD40. Even a dab of vaseline in that hole should do the trick

However if it has a bearing that goes in there you only want enough lube to help tap the bearing in as it is the central part of the bearing that moves and the outside should not rotate in that alloy foot peg holder bit.

The paint looks good, how much did that selection of parts cost if you don't mind?

Replied via rep system