Results 1 to 5 of 5

Thread: kawasaki GPX Ninja 250 leaking carbs

  1. #1
    Join Date
    3rd May 2005 - 07:22
    Bike
    2005 Custom Moped
    Location
    where the sun sets
    Posts
    434

    kawasaki GPX Ninja 250 leaking carbs

    Ive been helping a mate get his bike going. Had to reset one float on the twin carb setup. So it starts with the choke on but wont run without the choke and after it runs for a while it starts leaking gas from the carbs and its hard to see which carb is leaking. I now suspect a ruptured diaphram that operates the slide. Any advice from folks who have had the same problem would help

  2. #2
    Join Date
    3rd May 2005 - 07:22
    Bike
    2005 Custom Moped
    Location
    where the sun sets
    Posts
    434
    right Ive figured out by reading some old threads on this site it has a vacumn diaphram on the fuel tap. So I intend to use an old lawnmower tank to set the floatlevels with carbs out of the bikeany clues on correct float level would help

  3. #3
    Join Date
    3rd May 2005 - 07:22
    Bike
    2005 Custom Moped
    Location
    where the sun sets
    Posts
    434
    talking to myselfon the side of the crankcase it says 1.3L oil capacity. I drained out over 3 litres.

  4. #4
    Join Date
    3rd May 2005 - 07:22
    Bike
    2005 Custom Moped
    Location
    where the sun sets
    Posts
    434
    sorted it with new carb bowl seals. Goes good

  5. #5
    Join Date
    18th May 2005 - 09:30
    Bike
    '08 DR650
    Location
    Methven
    Posts
    5,255
    Quote Originally Posted by craisin View Post
    I drained out over 3 litres.
    of oil or oil that smelled like petrol?


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •