So, explain the core please?
So, explain the core please?
Don't you look at my accountant.
He's the only one I've got.
The core is going to be positioned above the throttle bodies and goes the full width of the chassis. The outlet of the turbo goes up and feeds into the bottom on the left half. It travels up to the top tank, across the top, and down the right side into the throttle bodies. I'm going to make ducts that feed air from the front of the bike to the intercooler. I'll also make a fuel tank that fits between the seat and the intercooler leaving a space for the cooling air to pass through the core. There may be louvres involved.
Very nearly finished with the flanges. Just need to drill the 2 holes in the flange to bolt to the turbo, left one. The other one will probably have a bit more machined off once I figure out how it's going to fit to the bottom of the intercooler core. Inside the turbo flange is 2.5° from about 5mm in through to the start of the other flange. Then the angle changes in 5° steps to 25°(per side) where it will open to the core. I'm not holding them together very well in the photo. When I do I can't see where they join. The OD where the connecting hose will be is 36mmOD
Can you do a tank like mine but smaller ? Mine was intended for BoB race length.
What about a tank cover/engine cover done in mesh over a light frame.
Feed air in via the OE fairing ducts through the frame.
I'm thinking of starting to mock up a tank tomorrow. The main mount will be the standard rear tank mount. The forward mount(s) will probably end up being the top bolts for the sub-frame. I suspect it will be about 5L when finished.
The bits of tube I have made aren't going to work. I'll be able to retain the turbo bit after a change but I'll make a new 2nd part to weld to the first. A 45° elbow from Mikunioz will fit and connect to the plenum. The elbow is 34mm ID so the alloy will have a reasonable taper.
Progress with duct for cooling air to the intercooler. Luckily the worst of the welding is on the inside. I'm still thinking about how to secure it at the front. There's a few options but I might leave it for a bit.
A 45° elbow arrived from Mikunioz today so I can get back to making the connection from the turbo to the intercooler. I already have the tapered pipe designed and just need to spin it up using the lathe. As usual the plenum on that side will be mocked up using old cereal boxes.
There are currently 2 users browsing this thread. (0 members and 2 guests)
Bookmarks