It sounds good too, all ready had a sit on it and made the appropriate Brrrmm Brrmmm sounds ha ha.Originally Posted by timg
Cheers
muzza
Hardcore Biker
It sounds good too, all ready had a sit on it and made the appropriate Brrrmm Brrmmm sounds ha ha.
Cheers
muzza
Forum whore
I have a new one for sale. plug and play for an FXR. No time to plug or play so going to sell it.
These come with a 4 stroke ignition curve loaded. Warning it is not the standard curve for an FXR. It will need to be setup on a dyno with a knock sensor.
PM me if you are keen. $250.00
Norf Welly Massif
MB50 Gear Shafts - good for the 6 speed conversion on the MB100??
The Unknown Rider
No8 Wire Extraordinaire
Yeah I doubt it, when I was there he had 4 & 5 speed boxes. You might be lucky & get a 6 speeder, but I'd want to go try it all out
Don't you look at my accountant.
He's the only one I've got.
Why Not???: MNZ975.
17" rims for spoke conversion:
http://www.trademe.co.nz/Trade-Me-Mo...-340808763.htm
gsxr250rotors:
http://www.trademe.co.nz/Trade-Me-Mo...-339737272.htm
Aclass fukeruperer
Honda rolling frame, in Whangarei
Hardcore Biker
Just bought it for $150.
Race it don't store it !
http://www.trademe.co.nz/Trade-Me-Mo...-344425661.htm
This was a Auckland bike I think and was very quick ..
Forum whore
from those photos it looks like the rear end is bent and the front wheel is off centre
Why Not???: MNZ975.
RS50 rolling frame
http://www.trademe.co.nz/Trade-Me-Mo...-346220081.htm
RAG Racer
Cheap race leathers
http://www.trademe.co.nz/Trade-Me-Mo...-345925421.htm
Gingas get life...Why don't murderers and rapists?!
RAG Racing
WFactor Racing 2010 - www.wfactor.org
Hardcore Biker
Cool frame to make a bucket from.
http://www.trademe.co.nz/Trade-Me-Mo...-346220081.htm
No8 Wire Extraordinaire
Well gee Bert's listed it 2 posts up.
Single sided SW limits wheel choice & rear wheel is a 2.75"
Hardly ultimate bucket frame. Later RS is better.
Don't you look at my accountant.
He's the only one I've got.
Hardcore Biker
Ahh. Didn't see that. Selective vision.
Even checked for it before posting just in case somebody already had.
Why Not???: MNZ975.
A few bits that might be of some use to others:
New front BUNGBON master Cylinder (14mm) & 34" Braided line (both still in plastic).
$60+postage
other bits
CBX250RS 1986 (twin carb model), in bits: make me an offer.
1989 CBR250 frame and forks & front mudguard. could suit a lonchin build??? $50 (and pickup)
1998 KTM125sx (last of the standard WP forks), needs a little love (could do with piston, chain and sprokets): $1200 o.n.o
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks