Who knows their sealants?

[BRV]

PRC is the best of the best, we use it in the aeronautical industry with no problems. As mentioned previously you should stop drill the crack first to stop it growing.

[98tls]

A lot of products work really well. They are let down simply by bad surface preperation or by corrosion on the other side -I agree with the araldite theory.
Have you priced up a second hand tanK??

The problem is getting one the same colour,crazy as it sounds get paint for this thing is a nightmare,i have the paint code 3YG,ive tried all over with no luck in fact to get paint for the undertray i ended up getting it from an outfit in England.....yea i know it sounds crazy,talking to guys on the TL forum from all over the world who havent had anymore success than i have with getting it,having a paint code is one thing,having the formula is another apparently,as far as i know its a silver base with the other colour over the top,yonks ago i tried to get someone to match the paint on a fairing panel and in the end bought a new one,crazy.

[EJK]

So did you succeed getting one?

If so, how and where did you get it?

[98tls]

Went with the stuff in your link mate,they have a list of suppliers on there website,supposed to be damn good stuff,yet to get it on but will post up how it goes.

[Kwaka14]

Go with the POR 15, you just have to very careful to follow directions and get it all absolutely dry and relatively clean first (not easy with a fuel tank) and then the etch primer cleans up any debris and the sealer sticks to that. it took me about a week to gaet the tank back on the old GPX I had lying around for a bit.