Yep, the top 3 are the servo position pins.
Lh = sensor earth, mid = sevo position out, Rh= +5V.
The pot does fail eventually, even in these newish R1 servo's.
So check you have 5-7K ohms on the outer 2 pins, and that the resistance varies between the middle and one end
as you wind the cable wheel back and forth with vice grips.
Lower pair are the servo motor power from ecu.
Run a 3 pin and a 2 pin plug for each, back to the ecu so you can program it easily.
Ive got a thing thats unique and new.To prove it I'll have the last laugh on you.Cause instead of one head I got two.And you know two heads are better than one.
Bookmarks