Quote Originally Posted by wobbly View Post
one of the very few reasons an Ignitech will not produce accurate ignition curves , is EMI. You MUST use resistor plugs and caps. The other issue is the proximity of the trigger or any other input/output
wiring to the coil charge wires.
They are on opposite ends of the loom plug for a reason.
I always run the coil wires on one side of the bike ( or whatever ) frame, and the triggers etc on the other side.
These simple things remove 99% of issues.
Also depin any unused loom wires, DONT coil them up to operate as very good antennae.
Thanks, Once again for pointing this out, I was just today moving a bike with a ignitech mounted on it, which I have been having ignition problems with for a while and I checked where the unshielded pick up coil wires are running. It is within 5mm of the Ignition coil. I think I now know why I was having problems.