Sorry , I wouldnt have thrown so much shit if I had realised you were polishing off the inside welds.
Here is your cone , angle cut in 1/2 , in SolidWorks.
First is a thin revolve 359.8*, then the cut keeping one 1/2 , then copy the part and keep the other 1/2.
Then using the cut sketches , assemble the two.
Then is SKUSA CR125 Pipe assembly using this technique.
Ive got a thing thats unique and new.To prove it I'll have the last laugh on you.Cause instead of one head I got two.And you know two heads are better than one.
Bookmarks