Bucket project progress

[Buckets4Me]

rg250w pipe and you are away
at least till you build your own but not out of epoxy and foam

[bungbung]

I've got a tzr250 chamber you can have

[F5 Dave]

Looking at the seat unit, I'd give yourself more front-to-back room (longer seat) or you'll be trapped in place too much.

[Coyote]

Hi Coyote.
I've just finished a similier project. I found some high density foam (used by boat builder) and for packing. the foam is heavy duty and can be glued and sanded, like wood without the work
then just glass over top (doesn't react) and then just remove.
I hunted around for epoxi and again found that most boat shops sell it very cheap (about $35 per litre).
anyway I hope this might save you a little time.

Bert

Is that the blue foam that comes in big blocks? I used that at school and tried for ages to find stuff like it. Asked on KB a few times. Had no luck. The expandable foam was the next best option. I'm keen on that foam for future projects. Go to a boat builders to get it?

Looking at the seat unit, I'd give yourself more front-to-back room (longer seat) or you'll be trapped in place too much.

You might see between the tail and tank the wood that held both has been cut. I was making it to look cool and forgot that I'd have to sit in it and I made it very tiny. I did fit, barely, but couldn't move. plus my legs were too long for the tank indentations. I'll be setting it further back. It was just further forward for the mock up photos so it'd sit on the frame.

Also the tail was meant to curve out where the frame curves out. That's too far forward so I'm going to have to modify the seat a wee bit.

I've got a tzr250 chamber you can have

Cheers man. I'll hopefully see you at the buckets