Doing NC30 carb balancing... need a screwdriver that will bend about 90 degrees to get underneath the carbs to adjust the screws...
Anyone got one i can use?
Ive only seen sets for 40-60 bucks... fuck that.
Cheers!
Doing NC30 carb balancing... need a screwdriver that will bend about 90 degrees to get underneath the carbs to adjust the screws...
Anyone got one i can use?
Ive only seen sets for 40-60 bucks... fuck that.
Cheers!
...Full throttle till you see god, then brake.
Crazy Steve should have one, but it may end up in your neck...
"It would be spiteful, to put jellyfish in a trifle."\m/ o.o \m/
ok thanks mate.
...Full throttle till you see god, then brake.
At a pinch I've used a bit out of one of those interchangeable screwdriver thingamy whatsits ( you know the ones)
If its to tight put a small ratcheting ring spanner on it.
Crude but effective
yeah i might see if i can clamp a bit with an adjustable spanner
...Full throttle till you see god, then brake.
I've got one you can use, but its up here in Snells Beach.
Harley Davidson: The most efficient way to convert gasoline into noise without the side effects of horsepower.
'Fast' Harleys are only fast compared to stock Harleys.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks