Snapped clutch cable

**rabidnz** · 25th January 2009, 12:06

is there anywhere in chch to buy the brass clutch cable terminators for me to solder on or does anyone have any i could buy off them??? I also need some inner cable can that be bought seperately?
Cheers all

**rabidnz** · 25th January 2009, 12:36

PS this is what clutch end fitting looks like. I thought the handle end fitting was soldered on so i heated it up but it was just a slug of solder which quickly became a puddle. Now im not sure whether to try and remove the clutch end of the cable in case it too turns to goo. Im sure i can jury rig something together ..

**JMemonic** · 25th January 2009, 13:11

Not a lot of change today, you could try some of the brake shops perhaps.

**imdying** · 26th January 2009, 07:22

Sorry, didn't see this yesterday, yes can help... you just want a new end?

Easiest way is to go into Safe R Brakes on Fitzgerald Ave and ask Guy or Gary to sell you what you're after.

**Motu** · 26th January 2009, 09:45

Make your own - for normal barrel lever end nipples I just use an 8mm bolt cut to length and drill a hole.The other end can be harder,some really small dia tubing is good...or again,just use a small dia bolt.

**rabidnz** · 26th January 2009, 13:25

hey cheers mate, tried the bolt trick , cant get the *** to solder, some brass tubing , now thats what i need. Hmm i think even acorn models might have it