Bucket bits wanted & services needed

[Ivan]

You can use a the old cylinder coils used on the old car ignitions condensers too. That's what I have used on Wobblers new f5, although it is a total loss system it works good.

arent these points setup 6v tho? or does it not matter how many volts the coil is?

[SHELRACING]

Yes that's right the original system is 6v. However bearing in mind this is a total loss battery system. It is a very simple to change to 12 volt using said 12v car (or bike) coil and condensor. The wiring circuit is simple. The points are not affected by the voltage, we even plugged in my 18v B&D drill battery once in an emergency. Wobbler reckoned the 18v gave the bike a bit more go. Although at 18v you would probably burn out your coil long term.

I can draw you a wiring diag if you want one.

Steve

[Ivan]

im trying to avoid total loss if i can so i dont have to run a battery as room is an issue trying to find somwere to mount it is going to be a pain and also i want to be able to get it out push it and start not worry about charging batterys etc

[koba]

I might have one of those, I'll have a look for you tonight and let you know.

Cheers, don't sweat too much about it.

[Dutchee]

Cheers, don't sweat too much about it.

You should get a package tomorrow or Monday. There are others that Henk can hunt down, but I thought I'd send you a pressie in the meantime. Have fun unwrapping it bwahahaha

[koba]

You should get a package tomorrow or Monday. There are others that Henk can hunt down, but I thought I'd send you a pressie in the meantime. Have fun unwrapping it bwahahaha

You bastards are too bloody good. Fuckers!

[Ivan]

also does anyone have a rear axle for a FXR GSXR etc I need a axle

[Henk]

FXR or GSXR? completely different sizes, length and diameter.

[F5 Dave]

ahh, -mere details.

[Ivan]

one to fit that hub you sent me the gsxr one

[Henk]

Not sure if that sprocket carrier was GSXR or Impulse. I may have one but will still need the required diameter.

[Ivan]

Not sure if that sprocket carrier was GSXR or Impulse. I may have one but will still need the required diameter.

ill give it a measure up over weekend

[husaberg]

Vanessa needs forks preferably front end with clip ons a radiator and a rear shock something along the lines of a 92 GSXR400 or NSR250 CBR250 etc.
I have got Got wheels bikes Master cylinder frame swing-arm rear sets engine.

Should have brought a donor bike but hindsight is a wonderful thing

[gav]

Vanessa needs forks preferably front end with clip ons a radiator and a rear shock something along the lines of a 92 GSXR400 or NSR250 CBR250 etc.
I have got Got wheels bikes Master cylinder frame swing-arm rear sets engine.

Should have brought a donor bike but hindsight is a wonderful thing

Whats it going on?

[husaberg]

Whats it going on?

Vanessa ????

NSR250 MC16 Frame.
NSR125 JC22 based engine.

Drawing is an artist impression only actual bike may differ in appearance.
Also actual results may vary also.