Bucket bits wanted & services needed

**richban** · 26th July 2013, 18:41

Originally Posted by speedpro

You could check the kart track at Tokoroa. I've seen a few FXR bits lying round there.

Oh funny funny. It was on the bench at home that day. Now safe inside my engine. for now

**speedpro** · 31st July 2013, 18:42

My sons bucket will need a new left front brake caliper real soon. Currently it has possibly a VJ22 caliper. Something similar from Nissin would be ideal. Anything will be considered as long as it's on the light side, 2 piston, sliding pin type.

**Drew** · 31st July 2013, 18:52

Originally Posted by speedpro

My sons bucket will need a new left front brake caliper real soon. Currently it has possibly a VJ22 caliper. Something similar from Nissin would be ideal. Anything will be considered as long as it's on the light side, 2 piston, sliding pin type.

RGV calipers are opposed piston type. I gather you're not after another one of those then?

**Drew** · 31st July 2013, 18:55

Since I'm here. Does anyone know how I can cross reference sprocket fitments?

I need to put a 428 sprocket on the CBR600 carrier. But I'm kinda drawing a blank on an easy way to look it up.

**husaberg** · 31st July 2013, 19:45

Originally Posted by Drew

Since I'm here. Does anyone know how I can cross reference sprocket fitments?

I need to put a 428 sprocket on the CBR600 carrier. But I'm kinda drawing a blank on an easy way to look it up.

ya ask someone else Drew
http://metalgear.com.au/searchByBikeModelSprockets.php
http://www.jtsprockets.com/catalogue/

**F5 Dave** · 31st July 2013, 20:15

RGV will be Tokico. I have a spare Nissin CBR400 twin slider, to you it's free if you can use it. I'll go drag it out when the cat decides to get up and check mount centres. Pretty sure it's left as I used the matching pair.

**F5 Dave** · 31st July 2013, 20:30

https://www.google.co.nz/search?q=cb...ENIQXb2IomM%3A

Yep it's a lefty, even has some pads. Check old CBR pic above for Nissin cal. 80mm bolt centres.

**speedpro** · 31st July 2013, 22:05

The caliper on it has 2 pistons on the outside. The disc on it is offset inwards to fit in the forks so it's pretty tight for room. Dave I'd be interested in that caliper but I'll do a measure and confirm tomorrow. Thanks.

**F5 Dave** · 1st August 2013, 06:57

Well it's not RGV you have. Check the link I posted, there are quite a few posted pics in that link +a schematic and brake pad pic. I used the other side as they fit RS forks and are very similar to RS original. Had it reattached to a brake line so should be ok inside, I bought as a set cw mc.