Bucket bits wanted & services needed

**oddgadgets** · 6th February 2010, 21:56

Thanks - I'll give them a try. I figure there will be a valve out there that will fit but it's hard to measure the correct length of the old one with a couple of 90 degree bends in the shaft!

**speedpro** · 8th February 2010, 07:18

At this time you should be considering just how big a valve could be fitted and looking for one of those. You then need to have a quiet chat to someone who knows what porting is all about. If you do go big make sure you do a very careful dummy assembly looking for clearance to the piston and also to the other valve.

**mbikeman1** · 12th February 2010, 21:28

im looking for a cb250rs front gaurd if anyone can help

**motorbyclist** · 13th February 2010, 09:28

pm magua and/or xwhatsit

**Kendog** · 14th February 2010, 10:13

Two-Stroke Performance Tuning, Graham Bell, Haynes

**Pumba** · 6th March 2010, 19:15

Ok my exhust has spat the kumara. I am after a muffler, anything considered,dont really want to spend to much

**ajturbo** · 6th March 2010, 22:34

so did my buell's pipe.. got a new sleeve for $55... saved me over $1500

**BOGAN02** · 6th March 2010, 23:24

Originally Posted by Pumba

Ok my exhust has spat the kumara. I am after a muffler, anything considered,dont really want to spend to much

Gday what kinda bike do you need the exhust for?

**Pumba** · 7th March 2010, 07:39

Originally Posted by BOGAN02

Gday what kinda bike do you need the exhust for?

Shit you have a point there, FXR 150

**motorbyclist** · 8th March 2010, 23:27

road legal or bucket legal? wouldn't be hard too hard to tune for a dirtbike pipe or similar....

**Pumba** · 10th March 2010, 20:24

Originally Posted by motorbyclist

road legal or bucket legal? wouldn't be hard too hard to tune for a dirtbike pipe or similar....

Bucket legal, yea I was thinking 4 stroke motorcross. Just a matter of finding one in my price range, which is sweet FA

**motorbyclist** · 10th March 2010, 20:59

not hard to make one.... back in high school I made a pretty nice one out of metal pulled from a skip at a local engineering shop....

**Henk** · 20th March 2010, 13:41

Anybody have a front master cylinder that would suit an MB50 lurking in a box. Possibly a whole front brake setup as I won't know how shagged the current set are until I can start pumping some fluid in.