Bucket bits wanted & services needed

[John_H]

Looking for an RGV250 VJ22 rear axle.

[quallman1234]

Looking for a Honda RS125 rear disc

[speights_bud]

Looking for a Honda RS125 rear disc

profile a piece of 4mm Alloy...

[quallman1234]

profile a piece of 4mm Alloy...

Theres that option, but its gotta go on the dyno. Dyno doesn't have brakes yet.

[speights_bud]

Theres that option, but its gotta go on the dyno. Dyno doesn't have brakes yet.

I have some nsr rear discs....

[F5 Dave]

Roll into your local MX shop and ask to look at a KTM50 MX sprocket..........

Yeah had a look at that when I was there on monday as they had some on the wall, but they were Talon at $100 a pop.

Also would the holes line up with RS ones?

Also also, they don't seem to go up to 48. We race on Kart tracks.

[koba]

Looking for a Honda RS125 rear disc

I have one you can borrow if you get stuck, until I need it that is.

[husaberg]

Yeah had a look at that when I was there on monday as they had some on the wall, but they were Talon at $100 a pop.

Also would the holes line up with RS ones?

Also also, they don't seem to go up to 48. We race on Kart tracks.

I think the one on my sons KTM is 46 or 47
Yes it will not just bolt on. but you mentioned keying it.......
They go from about 35-48t to cater for the different models and wheel sizes.
Don't just look at the SX go back to 2002 the wheels interchange even though the engines are very different from 2009 on
I think my last talon was $70.
The one i have here has enough meat to be redilled to suit.

[quallman1234]

I have one you can borrow if you get stuck, until I need it that is.

Probably take you up on that.

[F5 Dave]

I think the one on my sons KTM is 46 or 47
Yes it will not just bolt on. but you mentioned keying it.......
They go from about 35-48t to cater for the different models and wheel sizes.
Don't just look at the SX go back to 2002 the wheels interchange even though the engines are very different from 2009 on
I think my last talon was $70.
The one i have here has enough meat to be redilled to suit.

I'm keying a KX one on the 50 skimmed down so I still need an original RS centre. But the 100 is std setup. Think I'm sorted now, for the 100. Worn out solid one anyone?

[Gigglebutton]

I'm keying a KX one on the 50 skimmed down so I still need an original RS centre. But the 100 is std setup. Think I'm sorted now, for the 100. Worn out solid one anyone?

Do you still need the RS sprocket. I think there are some in the box of bits that came with the frame . Ali or Steel?

[F5 Dave]

Ally would be fab as I can cut it. More worn teeth the Better, as long as the centre is not fretted like mine is.

[Gigglebutton]

With or without holes?
Delivery address ?

[F5 Dave]

PM sent, thanks heaps

[koba]

Hey, anyone out there got an MB100 with a live plate?

I.E. "On Hold"

Keen on any condition.