Bucket bits wanted & services needed

[Gigglebutton]

Thanks for the suggestions lads.

Suzuki can get one for $109 OEM. There's a cheap one on the internets for $25 (don't want to risk a race round on a cheap coil).

I will do as suggested an find out the specs on the coil and see if there's a suitable alternative, I'll also email Wallace.

Liam at Fast Bike Gear has stick coils for them. He's an electrical engineer or some thing like that & already done the testing
Better than original apparently
0275985266

[Cheesy]

Where is a good place to get a GP100 cylinder bored in Chch?

[Grumph]

Where is a good place to get a GP100 cylinder bored in Chch?

It's getting harder here. Barry Lynch is cutting back on work now. Quite a few of us won't use HPE for various reasons. There were only a few reconditioners in ChCh who had boring machines that would go that small anyway.
My current advice is go to Wallace at Marshland Enginering.

[Drew]

Or just make one out of steam pipe and re sleeve it.

[Cheesy]

It's getting harder here. Barry Lynch is cutting back on work now. Quite a few of us won't use HPE for various reasons. There were only a few reconditioners in ChCh who had boring machines that would go that small anyway.
My current advice is go to Wallace at Marshland Enginering.

Ill give him a try, thanks

[Cheesy]

It's getting harder here. Barry Lynch is cutting back on work now. Quite a few of us won't use HPE for various reasons. There were only a few reconditioners in ChCh who had boring machines that would go that small anyway.
My current advice is go to Wallace at Marshland Enginering.

Ill give him a try, thanks.

Drew, its not that bad, just needs bored to an oversize piston

[John_H]

I'm after an RGV250 foot peg hanger for the gear shift side.

Cheers

[Flauski]

Wtd: Honda CB125 carb and exhaust hit me with a message if you can help

[andrew a]

Would anyone out there have a right foot peg holder for a Honda NSR MC21.
Thanks for your help.

[CBR97]

Hi all, im on the hunt for a zx12 engine,, 2003 if possible, but any year would be ok,, long shot i know, but worth a ask,,

cheers

[bartshumandad]

Hi all, im on the hunt for a zx12 engine,, 2003 if possible, but any year would be ok,, long shot i know, but worth a ask,,

cheers

Eeermmm, I don't think you will get it through scrutineering!

[Drew]

Hi all, im on the hunt for a zx12 engine,, 2003 if possible, but any year would be ok,, long shot i know, but worth a ask,,

cheers

If you've got a usable crank I can help. Though if ya need a motor for a big block Kawasaki you've probably run a big end .

[Madness]

Hi all, im on the hunt for a zx12 engine,, 2003 if possible, but any year would be ok,, long shot i know, but worth a ask,,

cheers

Try John at Motorcycle Works in East Tamaki, he had a wreck in there before Christmas.

021 0252 8167, 68A Greenmount Drive E.T.

[TZ350]

Looking for a complete Suzuki GN125 gearbox.

[mr bucketracer]

Looking for a complete Suzuki GN125 gearbox.

is gs125 the same ?