Hi need some advice. Recently went on a ride over to the coast. Just after porters pass stopped for a break only to find a sharp stone embeded in my brand new 2ct pilot road 2 rear tyre. Pulled it out only to find that the tyre had a reasonable hole through it. Got out the never used puncture repair kit and put one of the repair chord through. Stopped the leak and then topped up the tyre via the co2 canister all good. Went onto Greymouth and went to the local bike shop for advice re the repair, They suggested that I have it repaired properly at the local tyre shop. Long story but eventually got the tyre off and to the local ITS tyre depot. The said no problem and duly vulcanised a patch on the inside of the tyre. All good back to the bike shop back on the rim and away again. Got home and thought better check the tyre and have noticed that there is still a 5mm tear in the tyre between the tread where the stone was removed. Thought that it would have been sealed up but hasn't. Would you replace the tyre/ repair again/ leave it alone?
Exceptionally annoying on a tyre that has only done 350km before the puncture.
Bookmarks