New development facility opened

[Pumba]

You lucky bastard,

If only I had a workshop like that I'd move in, I could have me beer fridge in one corner wiv a sofa and tv, might have room for the bed too. I'm sooo jealous ,

No, if I was lucky it would be on my door step. Alas it is a small drive south from my location but I do consider myself rather fortunate to have it at my disposal whenever I need it.

And why waste a corner of the work area with all the items you mentioned. I may have failed to note that the area with the two smaller doors is in two levels, with the upper area about the right size for a two bedroom unit, so they say

[Pumba]

..and cool racing tractor..

Nice Moto Guzzi parked in the corner

It worries me that you are both talking about a Massy Ferg 35

[timg]

It worries me that you are both talking about a Massy Ferg 35

Nuttin wrong with Fergie's, I enjoyed mucking around on my TEA28 when I has a few acres to potter about on ........ but Guzzi's

[Sideways Sam]

The last time I checked, Moronsville wasn't a "short drive" from the city but hell it's worht it for a shed like that.........

Dude, It beats building engines on the kitchen bench in my apartment........

So you've got the cool ute, seriously cool folding aluminium ramps and the workshop from hell. How about putting some effort into the bike? you could start with fork seals, your fabrication engineer could just run a bloody big weld around where the seals used to be, that'd stop them leaking........

[Pumba]

How about putting some effort into the bike? you could start with fork seals

New seals went in today, so hopefully that solves that one of my problems. Been doing some measuring of sags etc and am chopping down some spacers so I can use the RG springs which are looking the best option I have at the moment