Activity Stream

What range is your torque wrench? I wouldn't trust any click / micrometer torque wrench below 20% of full scale. And they should be checked...

A lot can change over a race weekend. Liam has been treated really badly by Red Bull, or Christian Horner to be more precise, who clearly didn't...

He's always been a Guzzi guy, was the CX the Trail/ADV bike ?

Jesus what a lot of American crap. :tugger: Fuk em, pull ot the plug and let em all sink.

The RSW is a slightly oval inlet port horizontally, the RSA is slightly oval vertically on the disc axis. The RSA is better in that the narrower the...

DeBeading? I have a tool that I copied that I call the Biddliser after my friend Keith (Av's Dad). It is a square lever with a small spade like...

Pretty sure Frits or Jan wrote something similar to that about one doing that in practice or a race. ran good but refused to start again Pretty sure...

I have this setup. A 20mm ply base with a ply ring attached with carpet. A "cricket bat" for debeading the tyre. I have a block screwed to the wall...

. 170/88 ... Red Line on graph. I recall someone talking about dyno testing a rotary valve two stroke. Where the valve seized in the fully...

I made a board like this. And then sprained my thumb so bad I couldn't do anything like this so it waits a bit. The idea is you hold the rim...

Don't forget when he was lambasting crooked pollies his house got fucking firebombed and he had to go into hiding. Strayans are FERAL.

I am going to give it a go next tyre change. I believe you would need a dozen or so strong and releasable ties, lube and patience. Also can be used...

Initially, I was pretty shitty towards Martin when this story broke. But then when it came out that Aprillia did not want to extend the clause to let...

He makes some bloody good points between the two governments approach. Thanks for sharing.

I recall someone said(gresini guy) the data showed pressure in the front brake .I think the front brake guard prtoects more from the front