Activity Stream

Personally I think these new CBS look fucking awesome.Might actually buy one.Each to their own aye.

Kinda interesting. https://www.youtube.com/shorts/SIgQteZ0KO8

Ys I am aware of the danger of even moderate front brake application in tight turns,sorta a highside effect. I must brush up my low speed skills, i...

Yep, we used this as a metric to control the outlet restriction on a World Champ Jetski. The two cylinders dumped into a single oversized stinger...

1907-First School Journal published New Zealand pupils were for the first time able to read a schoolbook published in their own country. Anthony...

Saw this on one of the bookface pages: I'm not so interested in the port, but the comment about pressure. Tim seems to be a very...

The fact the camera isn't even pointing at the tractor kind of gives it away. AI has fucked everything.

So you already have one ordered, that's awkward.

You can have mine.

It's going off down here in the mitre ten carpark, 15C off a litre petrol vouchers included they are smashing it. Shame all your roadside venues are...

<iframe </iframe previous predictions you have posted have proven to be highly stupid...

Specialists:niceone: Thanks to you! If we bring back some more combustion pressure to camber and cylinder by adding advance in overrev. Think ;)...

Mine too, though the timing to get that pic at 314 kmh is a bit marginal. At least back in the day if something was fake it actually looked fake....

The torque hole is not jetting or ignition curve related. There are an infinite number of port timing/tuned length combinations that will work in a...

So who's getting ready to line up for their hantavirus vaccine? :killingme

Touching the front brake with a decent amount of lean angle at low speed is a recipe for a lie down. I've seen many people drop bikes when they start...

1926 New Zealand Railways Magazine launched Originally intended as a journal for the Railways Department’s 18,000 staff and their major customers,...

I would argue that clutch and throttle control are more important than the rear brake. The only time I am aware of using the rear brake at low speeds...

What are some of the causes of this dip? Obviously many possibilities, let's say on a engine that has had some time spent on jetting and a good...

Pull off dust seal, look for a snap ring. Remove top cap, unscrew from damper rod. With snap ring removed you use the two tubes as a slide hammer and...

Adding advance back in over the pipe has been used for years in JetSki racing, where the max rpm is limited by cavitation in the pump. It is used to...

What gob smacks me is how intimidated some people are as they think leaning their bike will make it fall over. I had a client who was aboyt 55 kg...

A soft rev limiter can be an option, but there is also another possibility. Delaying the ignition timing at high revs is intended to increase the...

This tickled my fancy. https://www.youtube.com/shorts/N5CCxCqQLf8

my guess : a soft rev limiter

Dear Specialists ;) What are the reasons for doing a ignition curve like the orange one? There is advance added at higher reves? Look at the red...