Bike Turntable

[Disco Dan]

Looking for a NZ supplier of these:

http://www.turnabike.com/products/saddle/

Small dolly for the center stand so you can swing bike about on it.

An engineer types think it expensive to make?

[RDjase]

Looking for a NZ supplier of these:

http://www.turnabike.com/products/saddle/

Small dolly for the center stand so you can swing bike about on it.

An engineer types think it expensive to make?

have seen the car version for sale somewere, "Go Jacks" or something like that, wernt to badly priced, would work with a bike i think. will have a sus out where there were

[Phantom Limb]

An engineer types think it expensive to make?

Not at all. You could get the body lazer / water cut from 10mm aluminium plate for around $100. Then you just need a bender (friendly local fabricator could help) and a set of 4 decent castors. The whole thing could be done for $200 - $250

[wickle]

close but not quite right



http://www.trademe.co.nz/motors/car-parts-accessories/tools-repair-kits/other/auction-533016517.htm