Grumph
18th April 2016, 14:16
Project started but won't be finished.
GSX250 motor gone through properly. Crank linished, clearances checked. Camchain VGC. GSXR750 cam profiles put on the cams, GSXR1100 valve springs fitted. New stem seals. Head lightly ported. Squish set. Cams dialled in. Clutch and box in VGC. Bores deglazed, rings fine. Balance shaft removed and oil galleries plugged.
No Ignition. Set up with no alternator rotor but the rotor and stator are with it. Crank is not cut.
Set of rough std CV carbs come with it.
Was intended for pre82 and CAMS junior Clubmans in a period copy frame. Other priorities take precedence. Should be a good'un.
Could be viewed at CAMS AGM meeting coming up.
GSX250 motor gone through properly. Crank linished, clearances checked. Camchain VGC. GSXR750 cam profiles put on the cams, GSXR1100 valve springs fitted. New stem seals. Head lightly ported. Squish set. Cams dialled in. Clutch and box in VGC. Bores deglazed, rings fine. Balance shaft removed and oil galleries plugged.
No Ignition. Set up with no alternator rotor but the rotor and stator are with it. Crank is not cut.
Set of rough std CV carbs come with it.
Was intended for pre82 and CAMS junior Clubmans in a period copy frame. Other priorities take precedence. Should be a good'un.
Could be viewed at CAMS AGM meeting coming up.