Honda bit wanted regulator/rectifier

[Daz1203]

Hi People,
Anyone know where I can get a regulator/rectifier for a 1998/99 Honda CBR1100XX the part id number is SH638-12 and its got 7.N underneath.
Cheers....Darryl

[Grub]

Hey Daryl, I don't have a rectifier but your thread is a good catch-all, can I piggyback on it and list the bit that I want please?

I would like a standard 600F4 or 4i seat to try out. Any condition is ok, even just the pan.

[vifferman]

Hi People,
Anyone know where I can get a regulator/rectifier for a 1998/99 Honda CBR1100XX the part id number is SH638-12 and its got 7.N underneath.
Cheers....Darryl
Most bike dealers should be able to get one for you - that number indicates it's a Shindengen R/R. Shindengen make them for Honda, Ducati and some other manufacturers. I dunno who imports them, but I bought one from Spoectrum and the second one from Mt Eden M/C, who both got them from Eurobike or whoever the importer is.
If you buy a "genuine" Honda one, they WON'T give you a warranty on it, it will cost twice as much, and it'll just be a Shindengen one anyway, as Honda don't make them.

[Blackbird]

Hi People,
Anyone know where I can get a regulator/rectifier for a 1998/99 Honda CBR1100XX the part id number is SH638-12 and its got 7.N underneath.
Cheers....Darryl

Hi Darryl. Reg/recs for the earlier Blackbirds were known to fail on occasions (as you've just found out I suspect). The problems were fixed post 2002 and a lot of people swap to the later reg/rec as a precautionary move.

Send a message to JAWS (John Smith) in the UK. He specialises in Blackbird parts and his service is legendary throught the Blackbird-owning world. I've bought heaps of aftermarket stuff from him. Usually takes a week to get here. His website is: www.jaws-motorcycles.co.uk/. BTW, some people use Yamaha R1 reg/recs as a replacement. If you want to know where the good Blackbird websites are, just send me a PM.

Cheers,

Geoff

[klyong82]

I bought one for my Fireblade from Ebay and paid 1/3 the price including postage compared to what Honda NZ was charging. Was told by a bike shop best to go for aftermarket rectifier as the pre-2000 CBR 600,900,1100 OEM rectifier were notorious for failing (bad design).

[klyong82]

I would like a standard 600F4 or 4i seat to try out. Any condition is ok, even just the pan.

Try this bike wrecker on trademe.

http://www.trademe.co.nz/Trade-Me-Motors/Motorbikes/Parts-accessories/Frames-bodywork/auction-118025769.htm

He even has a wrecked F4i double seat models

[Matt_TG]

EconoHonda (http://www.econohonda.co.nz/) may be able to help.

[Daz1203]

Cheers for that info also found a wrecker in Ngaruawahia (Bikebusters)who has a contact in Aus that can get them for 1/3 price