PDA

View Full Version : Yoshimura pipe GSXR 1000 k6


Madnes
17th June 2008, 19:14
Yoshimura exhaust will fit a k5 or k6 1000. Note this is a half system that connects to the end of the standard extractors and removes the SET valve. This pipe has had a small repair not really noticable unless standing next to the bike(see pictures) This is a race spec straight through pipe so is quite loud. It is a Yoshimura Japan spec not USA. This pipe can be heard running(still on bike)

Listed on Tardme

http://www.trademe.co.nz/Browse/Listing.aspx?id=160966863&ed=true
Pussy
17th June 2008, 19:34
Cheap yoshi! And they make the K6 1000 go VERY well.... don't they, UKSteve??
Boob Johnson
17th June 2008, 19:40
Cheap yoshi! And they make the K6 1000 go VERY well.... don't they, UKSteve??
Hell yeah, bet that gets pushed well over the start/reserve.

Good luck with the auction, you wont need it
munterk6
17th June 2008, 20:19
Pity bout the damage, but its still good value at $390. I paid $750 for mine new...then had the fuel re-mapped and a K&N filter and it made a noticeable difference in throttle response and......noise:whistle:
Squiggles
17th June 2008, 20:41
i believe you can even get replacement yoshi badges.
Boob Johnson
17th June 2008, 20:49
i believe you can even get replacement yoshi badges.
Don't you come anywhere NEAR my bike Squigs :laugh:
CHOPPA
19th June 2008, 00:11
sucks it dont fit the k7!
boomer
19th June 2008, 04:36
sucks it dont fit the k7!

we can get yoshi pipes in Choppa.....

http://www.kiwibiker.co.nz/forums/showthread.php?t=76149

and

http://www.kiwibiker.co.nz/forums/showthread.php?t=71752
CHOPPA
19th June 2008, 11:11
we can get yoshi pipes in Choppa.....

http://www.kiwibiker.co.nz/forums/showthread.php?t=76149

and

http://www.kiwibiker.co.nz/forums/showthread.php?t=71752


Sweet! Its mainly for resale cause i dont really ride the bike, whats your opinion on the best pipe for resale bearing in mind id like to get rid of the cat
boomer
20th June 2008, 08:30
Sweet! Its mainly for resale cause i dont really ride the bike, whats your opinion on the best pipe for resale bearing in mind id like to get rid of the cat

i have a single sided pipe on mine (Racefit Growler) but i'm partial to seeing the twin yoshi; either the carbon trc or the tri

im not sure either will add much more to resale value over the stainless steel versions, both of which remove the 12kg ballasts *incl cat