PDA

View Full Version : 52mm clip-ons wanted


sinfull
11th January 2009, 19:40
Any racers out there with some 52 mm billet clamps they can lend me, or that they want to offload ??? I screwed up and took someones word without putting calipers on my stauncheins that they were 50 mm so have some that are too small for sale or swap !!!
sinfull
12th January 2009, 14:38
Bump ! None in the country and a 14 day wait which i haven't really got !!
Anybody ??
Dooly
12th January 2009, 14:46
You got that bloke's address for the wheel mate?
sinfull
12th January 2009, 14:59
You got that bloke's address for the wheel mate?
Just rung the guy (got his mrs) and they are in Napier itself ! Georges drive, operating out of a private address so you were right !
Are you planning a visit into napier at all in the next couple of days ?
Dooly
12th January 2009, 15:05
The missus is always in Napier with her job and can pick up, or if not I'll shoot over and get.
Let me know when its ready to pick up, and their address, and whens best to get.
GIXser
12th January 2009, 15:43
you doing the nats??
Yow Ling
12th January 2009, 17:29
why not bore then to 52 mm, might be an hour or two work
sinfull
12th January 2009, 21:39
you doing the nats?? Nah mate ! First start is in clubmans, rnd 2 PMCC at Manfield ! See where i go from there lol Have quite a few seconds to knock off before i'm gonna be anything other than traffic for the faster guys !

why not bore then to 52 mm, might be an hour or two work
Yeah its something i just finished looking at, total wall thickness in the outside is 4 mm so thats fine but there's not much meat between the staunch wall and where the bar slides in ! Done a bit of measuring and a few sums and there might be about .3 mm left in the wall at one point, after honing it out and being billet shouldn't (fingers crossed) compromise the strength
GIXser
12th January 2009, 21:45
Nah mate ! First start is in clubmans, rnd 2 PMCC at Manfield ! See where i go from there lol Have quite a few seconds to knock off before i'm gonna be anything other than traffic for the faster guys !

Yeah its something i just finished looking at, total wall thickness in the outside is 4 mm so thats fine but there's not much meat between the staunch wall and where the bar slides in ! Done a bit of measuring and a few sums and there might be about .3 mm left in the wall at one point, after honing it out and being billet shouldn't (fingers crossed) compromise the strength

reason why i asked is im at the nats and i have a spare set, there, but also need it for back up, so would have lend them out:)
sinfull
12th January 2009, 21:57
reason why i asked is im at the nats and i have a spare set, there, but also need it for back up, so would have lend them out:)

Aww right cheers for the offer anyway, so your in timaru this weekend then, good luck aye !!!