SHE LOOKED UP AT ME WITH BLOOD IN HER EYES
THEN HER SKIN FELL OFF
AND SHE PROMPTLY DIED
IT WAS EBOLA, LA LA LA EBOLA
Heck Woodhills so smooth I just sit 90% of the time and just about always through the corners and I tend to keep the feet on the pegs unless trying to weight the front end more. I do stand in some of the wider faster easier access trails or the MX track where the sand is softer and where weighting the pegs from side to side makes for better maneuverability without having to steer with the bars but because I try to stick to the single track I hardly stand at all.
I sit mostly and stand only when I have too and use any bumps to move me into a standing position or back into the seated position. I find that sitting and making small weight shifts that the traction is better without having to pull back on the bars which is just tiring in the long haul. When I'm standing I'm riding forward or central without pulling back on the bars and I use the power to keep the front light. For longer rides I try to stand more just to stretch my legs but for fast single tracking sitting works best for me.
Does your lever need adjusting? I'm actually not sure how my foot to lever feels when i'm standing as i'm yet to actually move my foot haha.
I have ridden a RM though which when sitting the lever position had me having to point my foot down then kinda tuck it under as it was too close for me - i think that was the problem anyway![]()
Adjust your levers to suit your riding position...every lever, brake, gear, clutch is adjustable for position and you need to be comfortable to ride smoothly. Put your bike on a stand (upright) get on it and take your normal riding position, standing or sitting, and then adjust all the levers so they are set for the natural position of your feet and hands.
I ride standing and set the gear lever to just beside my big toe so i can easily rock my foot down or up to change gear, I have the instep of my boot on the peg and just rock the boot on that to change gear....same with the brake lever.
Get set up properly and you will find it's easy to control the gears and back brake standing or sitting, spend the time adjusting the bars and levers to get yourself in a comfortable position.
As the other have said try a few addjustments on levers mine are set so i can just sorta roll tilt foot forward you'll need to shift foot forward a small amount and gear shift is there kinda hard to explain. After 20 something years od it kind just something yah dont think bout. I kinds catch it with the outer edge of boot rather than havin foot right under it, Edge of foot tends to sit just to the side of lever ten it quick and easy to change up or down.
[SIGPIC][/SIG
That's awesome guys! Sounds like I have some adjustments to make
On sweeping sandy turns, no hard and fast rule for me.
Sometimes sit sometimes stand, I like full bag of tricks available as every turn always a bit different in some way; Intended line, depth/softness of sand, sand snakes & berms, size/spacing of bumps etc.
Mainly bumpiness determines my seat/stand but also depends on estimated likelyhood of holding a clean & stable line. If there's a good chance of needing a dab or gliding the size12 for tripod stability, I don't want to be standing. Often seems i can be a bit more agressive if seated
If sand is smooth enough, might not be much difference in pace between sit or stand - but then again maybe a bit better drive if meat-on-seat? (ref Humai's good description re sit/stand weight effect on steep climb)
No doubt about it though, nailing a sandy turn feet up (sitting or standing) is very satisfying. Something I like to do every now and then is to ride a whole trail (tight or open) keeping feet up all the way through. For me it really focusses attention and promotes accurate riding. Seems like the more i do the feet up excercise, the less i need to take a dab.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks