Drilling duc end cans

[woody68]

Hi guys.
Are there any former ducati Paso or sport owners out there who have drilled the stock cans on these bikes.
Theres a baffel plate about 5 inch's from the end of the cans and I would like a bit more sound but don't want to get rid of the stock cans my bike is in mint stock trim and I would like to keep it that way.
Just with more noise.

[Sensei]

Hi my both my Ducati's had Factory open pipe's on . Its not a biggy to have them opened up by someone have done shit loads as I'm a Fitter welder by trade so piss easy . Friend has a 750 the same as yours . excellent little bikes
Any bigger pics of your's ??
SENSEI

[woody68]

Here some pics
OK you reckon to drill the baffel plates then

[Sensei]

I see your mufflers are different from the open ended ones on SS / 93 907 I had . I drill the rivet's ut then gut the in side's then rerivet the end cap back on to muffler . But with your type drilling my be the only option . Bike may need retuning after they are done will see when you ride it . Would start with one small hole first then get big till you get the tone you want .
SENSEI

[woody68]

I was thinking along those lines to.
Thanks mate.
Good to have a little advice on these things, I've got lots of riding to do so would hate to miss that.
Theres alot of runs at this time of year.
I may put some new cans on in the future when stock ones are stuffed but there good for now.