"The world is a strange sad place. Ride as often as possible and try not to think about it".
can someone with a CR 125 or 250 please measure the distance between the 2 bolt holes that hold the chain slider on
thanks
we may just go where no ones been
you're lucky im bored! and its 3 bolts. the 2 front ones are long and go right through with a nut on the back side, the rear one simply threads in to the lug on the swingarm
we may just go where no ones been
Wait wait wait... so your bike has the heart of a Honda?!!![]()
sorry i dont have anything older around to have a look at. they should be the same from 03-07 , but LVN CR250 has the previous generation - he's just signed up. he might be able to help you out
Il go and measure it when it stops raining
* had a look, 99% sure my 2000 model one is the same as boooms
cheese measured that it was 33mm from the two front mounting holes.... which matches on my bike perfectly....
we may just go where no ones been
I might have a chain guard on the KX125 '97 roller that might adapt?
This any use? The other pix are for Krads benefit should he spot them!
Heheh. You always were subtle.
well the CR slider nearly went straight on. only needed some minor modification.......angle grinding.
not sure how long it will last though...
but if it wears through, like what appears to have happened to the one the bike did have judging by the remains, ill make one using rollers like i wanted too
honda part count up to: air filter, fork guards, piston + ring, chain slider, front and rear brake pads, probably the brake assemblies....
we may just go where no ones been
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks