990 KTM front sprocket

[sparker]

Just replacing 17 tooth front sprocket on KTM 990 Adventure. What is the torque setting for the sprocket securing nut?

[junkmanjoe]

what year is your bike.

this is for the 2006 990 A and 990 A,S

TECHNICAL SPECIFICATIONS – CHASSIS »
TIGHTENING TORQUES – CHASSIS
Exhaust nuts on manifold M8 evenly, do not bend sheet metal
HH bolts on exhaust suspension M6 Loctite 243 + 12 Nm
Spoke nipple M5 5 Nm ± 1 Nm
HH nuts on rear sprocket bolts M10x1,25 Loctite 243 + 50 Nm
Hexagon nut on engine sprocket M20x1,5 sheet retainer + 100 Nm
Engine carrier bolts M10 45 Nm
HH bolts for side stand bracket - engine M10 Loctite 243 + 45 Nm
HH bolts side stand bracket - side stand console M10 Loctite 243 + 25 Nm
HH bolts side stand mounting M10 Loctite 243 + 35 Nm
HH bolt spring retainer side stand M8 Loctite 243 + 25 Nm
HH bolt side stand switch M6 Loctite 243 + 10 Nm
HH bolts for underride protection M8 Loctite 243 + 25 Nm
Drain plug on oil tank M12x1,5 25 Nm
HH collar screw for front ABS sensor M6 6 Nm
Special screw for rear ABS sensor M6 Loctite 243 + 8 Nm
Other bolts on chassis M6 10 Nm
M8 25 Nm
M10 45 Nm
Other collar nuts on chassis M6 15 Nm
M8 30 Nm
M10 50 Nm
93
there is a thread in this section for 990 / 950 owners to ask and post away at our leisure,
post up a few photos of your bike,

JMJ