Name the part

[D3ALN]

Hey guys Ihave oil leaking out where my oil filter is on my 07 yz250f there is no rubber thing that there normally is on the cover thatis held on by the 3 alan key bolts. what is the name of this seal/o ring and where do i buy from.

[placidfemme]

Hey guys Ihave oil leaking out where my oil filter is on my 07 yz250f there is no rubber thing that there normally is on the cover thatis held on by the 3 alan key bolts. what is the name of this seal/o ring and where do i buy from.

It's called an "O-Ring" and you can get it from a Yamaha Dealer

Edit:

Try Barry's Motorcycles in Hastings, or give me a call on 06 842 0010 (Bay Motorcycles) and I will source one for you.

Double Edit:

There are also 2 smaller O-rings that fit in where the two smaller Allen Key bolts go in, if the YZ is leaking you may also have lost those two smaller O-rings, they shouldn't cost too much extra, so as an added safety measure, I would recommend getting those too. Worse case scenario you have spares!

[D3ALN]

It's called an "O-Ring" and you can get it from a Yamaha Dealer

Edit:

Try Barry's Motorcycles in Hastings, or give me a call on 06 842 0010 (Bay Motorcycles) and I will source one for you.

Double Edit:

There are also 2 smaller O-rings that fit in where the two smaller Allen Key bolts go in, if the YZ is leaking you may also have lost those two smaller O-rings, they shouldn't cost too much extra, so as an added safety measure, I would recommend getting those too. Worse case scenario you have spares!

cheers for that

[barty5]

http://fiche.worldofpowersports.com/...hadb&A=397&B=9

[pete-blen]

Anywhere that sells berrings / seal etc...
be lucky if it cost yer $1... Yamaha would charge ?
With these type of parts...O-rings / most seals / berrings
Yamaha/Honda/Suzuki/Kawasaki etc buy them in..
just like you can ,for a fraction of the prise
the bike makers charge..no waiting for them...

[Jay GTI]

Olly the Oilseal?

Am I the only one playing this game...?

[del-solider]

Just go to any bearing and oil seal place theyll match one up for you.

I had to get two seals for my kxf, $58 for genuine $14 from a bearing shop.
Was Exactly the same seal.
Above post is right thats what the manufactures do...

[D3ALN]

there is no seal oin there to match up it is gone.

[barty5]

ive got yzf's at work i can measure them up if you like but wont be till thursday

[pete-blen]

there is no seal oin there to match up it is gone.

take the cover with yer...

I have O-ring section in long lengths from 1.5mm to 5mm section in .5mm steps..
cut to length supa glue the ends togeather.... I have NEVER not got the right O-ring
in my shed...