Lowered handrails

[FJRider]

I was after something that would cost me under $200, not $20,000 But thanks for the hint.

A new set of bars should set you back about $30-40 bucks (at the most). Half an hour to fit with basic tools ... yourself.

[ducatilover]

I was after something that would cost me under $200, not $20,000 But thanks for the hint.

Flat bars should help you out then.
Or as someone else said, clip ons from an SV650 (I expect they're 41mm forks, so there's a huge variety of bars that'll clamp to 'em)
With clip on bars, you may find you have to shorten your cables and the brake line might look a bit silly as it'll be at a different angle.
On the other hand, on my ZZR600 I have got away with just a shorter clutch cable and I may put a shorter top front brake line in it.

[slofox]

I was after something that would cost me under $200, not $20,000 But thanks for the hint.

Boyds have a GSX-R600, 2010 model, for just over half that...

[FJRider]

Boyds have a GSX-R600, 2010 model, for just over half that...

Yea ... I saw that. A bloody rip-off eh ....

[ducatilover]

Yea ... I saw that. A bloody rip-off eh ....

Almost Yamaha amounts of rip-off!

[Asher]

A double bubble screen would help with the wind resistance problem

[slofox]

Yea ... I saw that. A bloody rip-off eh ....

For sure.

's a black one...less than 1000km on it as well.

[FJRider]

For sure.

's a black one...less than 1000km on it as well.

1000 km's ... its worn out ...

[rossirep]

Folks,

I have a Kawasaki Ninja 650R 2008 and I am keen on getting a lowered handrail for a lesser air resistance and more fun. I am after something good but not very expensive.

Any suggestions what to look for and/or where to go?

Cheers.

sell ya crappy kwaka 650r and get a YAMAHA R1 ..!!!!! problem sorted..

[ducatilover]

sell ya crappy kwaka 650r and get a YAMAHA R1 ..!!!!! problem sorted..

Or a VT250?

[Floppy disk]

Thanks for the hints guys (except for calls to change my bike. How dare you?? LoL). I have enough ideas to start talking to shops without looking like a blind man in a brothel. And here is what I will trying to do: http://www.youtube.com/watch?v=nhPcz23629I

Awesome!

[JimO]

I have enough ideas to start talking to shops without looking like a blind man in a brothel.

he would be asking for some fresh blue cod

[nzspokes]

I have a pair of flat alloy bars that are drilled for homda controls. I dont need them as my new bike has clip ons. $30.

I only rode them twice as it didnt work on my bike.

[Bassmatt]

Thanks for the hints guys (except for calls to change my bike. How dare you?? LoL). I have enough ideas to start talking to shops without looking like a blind man in a brothel. And here is what I will trying to do: http://www.youtube.com/watch?v=nhPcz23629I

Awesome!

Not for $200 or less