Custom gasket makers?

[Akzle]

it was suggested that I got some gasket paper and put one in temporarily, but that's something I'd rather not do... so does anyone know of anywhere in the Welly area that does custom gaskets?

there need be nothing temporary about it. although possibly beyond your tooling/skillz? (hole punches?)

take what's left of the old one to any factory that has engineers onsite, particularly if they have lots on nice shiney flanged stainless pipework outside - they will be able to sort you out for beer.

[nadroj]

http://shuk.co.nz/

[mashman]

there need be nothing temporary about it. although DEFINITELY beyond your tooling/skillz? (hole punches?)

Fixed for ya

small ball pien hammer and a small shet of copper ( or ali ) and make it yourself

20 min max

slap a bit of copper grease and bobs our uncle

make sure both faces are flat

stephen

see above where bob would turn out to be my gay aunty's cousin twice removed with a seriously fucked up face. Me and materials for making things we don't mix well at all.

[Subike]

I have to say that a flat gasket like that would take about 20min max to make,
As you have the original gasket, and as you say, its the bolting points that are stuffed,
There is no problem. it is a pattern that any semiskilled pipe fitter could reproduce with his eyes glazed from a night o the piss.
The two links given in this thread are good, either one would be more than able to cut a simple gasket like that.

http://shuk.co.nz/

http://christchurchgaskets.co.nz/ind..._products.html.

You should be able to get it done within 2-3 days. so get them to make a dozen,
Because if it is a reoccurring problem, you have spares of your own.
There could be other owners with the same problem.
And you may recover the costs by on selling to them...

Might even be cheaper to get a doz, than import one,
Defiantly Faster

[Howie]

But a sheet of THIS , some other stores may also stock it.Ring a friend with an Engineering background if your worried about having a shot at making one yourself.

[Madness]

Mashy, there's a crowd in Otaki that make gaskets too.

[nosebleed]

Help me, help me.

Hey Mash, flick a PM to Sensei.
2x birds with one stone, Aprilia's and engineering.

[mashman]

I have to say that a flat gasket like that would take about 20min max to make,
As you have the original gasket, and as you say, its the bolting points that are stuffed,
There is no problem. it is a pattern that any semiskilled pipe fitter could reproduce with his eyes glazed from a night o the piss.
The two links given in this thread are good, either one would be more than able to cut a simple gasket like that.

Might even be cheaper to get a doz, than import one,
Defiantly Faster

I R fucktarded in more ways than the several thousand I have already displayed, there's no reason the bike should suffer too... but I probably will get a few depending on where I gettem.

But a sheet of THIS , some other stores may also stock it.Ring a friend with an Engineering background if your worried about having a shot at making one yourself.

I have no friends ... let alone any that are engineers, well not those types of engineers.

Mashy, there's a crowd in Otaki that make gaskets too.

Ta... might find out if ze vife is lookin to take the kids up the coast at some pint during the week... although the below sounds like a goer if the man has time.

Hey Mash, flick a PM to Sensei.
2x birds with one stone, Aprilia's and engineering.

Cheers, will flick that PM right the noo.