Yamaha clutch lever wanted, Christchurch?

[zephyrheaven]

Anyone know who would be open tomorrow / late today (sat) for a clutch lever, just dropped it & kapow - one finger clutching aint much fun & had a nice day planned tomorrow...........
Have had a google / call around & everyone is off on their bikes sigh

Cheers in advance

[Jinxycat]

pity your in the ch ch

[timmehpwr]

http://www.pitlanemotorcycles.com/

these guys relocated to the main street of Darfield and are open on Sundays from 10am, they carry a lot of levers so could be worth a try

[zephyrheaven]

thanks for that - heading out now!

[zephyrheaven]

Thanks again, meant I had my 1st ride on new bike today - mega fun, best stress toy ever - need some riding pants now tho, hmmm - cheers Pit Lane helpful as & had everything in stock

[timmehpwr]

nice guys eh.. saved my bacon one sunday when i dropped my bike down mcleans island and broke the clucher leaver off at the perch, crashed it through the gears to their shop and got a new one where did you go today?

[zephyrheaven]

Went to Weedons Ross Rd , waimak was brimming - pretty cool, rode down next to the river for a bit heading east - paused, looked behind me & the river had jumped the bank & followed me!?! Hit some trails, found some more water - stalled & Yamaha excellence started straight back up phew. Headed into the tracks for a bit was great
Bike is set up just right for a fat mid life crisis guy, must buy some riding pants however - jeans aint cutting it

Much more fun than my mountain bikes thus far - but I can see them complementing each other as time goes on

Some friendly blokes there too, felt like a total noob but was nice to have yarn to some obvious hard core riders afterward

I love my 4x4ing but this bike is getting me onto tracks Ive only dreamed of, and taken me back 15 years to when I rode every day in our forestry block - good times

Thanks again for the headsup - will be using them more & more as Im over this side of the 'mak - gonna look for more nice quiet places to ride too, if you know of any?
Still running in new motor at this stage - but it goes like a cut cat which is awesome

Thanks, James