It would seem so? Although, then it also says that all 250's are learner legal so one could potentially argue over it? It seems a bit of a grey area though.
However, should I be going for an exemption for my bike due to having it beforehand, even though its likely that its making under the manufacturers specs? I'd love to have it dynoed but for a 250, its not worth the money
There is no requirement to fit an OEM exhaust, or any other OEM part. The only requirement is that the replacement part must not increase the power to weight ratio. Even if it does change it slightly, I'm sure that as long as it isn't louder, and so draw attention to your bike, then no-one would be worried.
Time to ride
Not the only class of vehicle that has to deal with this sort of thing, low volume certification is the bane of any person wanting to modify any vehicle, from a mini to a kenworth truck. Put a set of wide wheels on you Corolla, then add some clip on flares for the guards, certification needed, and thats the easy one. Look out all you cafe racer builders, street fighters, choppers, etc, how long will it be till certification will be needed to operate these on the road...I would advise that you keep your bike up to WOF spec at all times, not attract the attention of the Popo's, and you should have a good ride.The last thing we want is to start being labeled along side the boy racers for modified noisey dangerous vehicles. Al though certain makes of bike already encroach upon the sound regulations from new...
Last edited by Gremlin; 21st October 2012 at 20:59. Reason: Quoted Embedded Media Removed
To be old and wise, first you must be young and stupid.
Now, this might just be me reading logic where none exists, but......
The way I read it, is any 250 that isn't a 2smoker is legal. This excludes shit like massively fucking with it (IE swapping motors or motor internals). You'd have to meet an officer that had just found out his wife was shaggin his dog or something to get pissy about an exhaust on a 250. And considering what Rastus has been saying, most don't even know the rules have changed. It'll be a cold day in hell before somebody gets written a ticket/non compliance for a zorst on a 250.
I suspect (and again, might be trying to insert logic where non exists) but I suspect that the whole "must not modify bike to increase power to weight ratio" is largely for either A) bikes that are only just fit within the 150kw/tonne limit,
Or, the most likely candidate, bikes that are restricted to meet LAMS requirements. Shit like the restricted Hyobag 650s. I would imagine that the main intent of the rule regarding modifications that increase power, is aimed at warning people not to derestrict their bikes.
Regardless, if it was me on a 250 and I had an aftermarket can, I wouldn't worry about it. You'd have to meet a cop that A) knows about bikes, B) knows the LAMS rules, and C) is either properly pedantic, or having an extremely bad day and D) to fail the attitude test. Particularly if it's not an obviously after market can.
My 2cents anyway.
Last edited by Gremlin; 21st October 2012 at 21:00. Reason: Quoted Embedded Media Removed
Don't try to bring logic to legislation discussions ...
As legislation is written ... unless the 250's are on the forbidden list ... they are automatically LAM's compliant. As such ... subject to LAM's rules and legislation.
Cops that know little of the new reg's will be more of a danger ... than those that do. You want to risk it .... go ahead.
Logic and legislation do not mix. No modifications to increase power is allowed. No exceptions (or limits) are stated.
Actually ... motorcycles that have restrictions that can be removed are NOT on the allowed list.
D) would be the usual reason ... depending on what reason ... the cop had stopped you for anyway.
Value for money.
When life throws you a curve ... Lean into it ...
I was up in Timaru the other day,on my way to the Suzuki shop up there, i ended up with a cop on my arse,i pull over and stop at the bike shop,so does he,he says "is that a 98"
im thinking "wtf" then upon walking round the bike he says "well it was a TL1000"
Turned out a nice bloke who had one the same frogsnot green way back,no mention of any legal issues re front end etc,he loved it.
Be the person your dog thinks you are...
Yeah, fair enough all around. Like I said, was probably just reading intent rather then actual fact, based on my latest dealings with the NZTA ( We didnt "MEAN" to leave up the document saying you could finish up your L and R process under the old system).
Minor point though, there are heaps of restricted bikes on the LAMS list where the restrictions can be removed. Nearly all of them in fact. Just with varying degrees of expense and difficulty. There are a few bikes on the list made specifically for LAMS type laws, but most of em are simply the same bike with some ways shoved in to restrict power output. From what I was reading ages ago, a lot of em are restricted either at the ECU or carbs. The hyobags I think it was you used to just replace a bit in the carbs and off you go.
Wait for it......the master will have a reply soon
To be old and wise, first you must be young and stupid.
It's a really simple reply ..... I'll highlight the important bit (and think carefully on its implied implications)
ANY modifications for the purpose of increasing horsepower is forbidden.
Regardless if the modifications are simple or not.
Key words ... for the purpose of ...
The master has spoken ...
When life throws you a curve ... Lean into it ...
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks