RF900: A Questions

[Fast Eddie]

http://www.mcr.co.nz/community/past_..._dyno_shootout

Oh mint, might go down and have a nosey.. I wonder if its there onsite.

Might save me strapping my shit to a dodgy trailer dyno!!

[Sliver]

Oh mint, might go down and have a nosey.. I wonder if its there onsite.

Might save me strapping my shit to a dodgy trailer dyno!!

Wonder if any other bike shops do it...MCR wont get 1 cent of my money ever again.

[Fast Eddie]

Wonder if any other bike shops do it...MCR wont get 1 cent of my money ever again.

Not too many bike shops in dunners.. ride round to each of em.

What MCR do to you? I've only had good dealings with them..sometimes they are a bit short and sharp but they seem to be busy all the time.

Not that I spend much money with them.. bought some bearings and a camchain and an airfilter off em so far.. maybe few other bits n pieces. They don't hike the price up too much at least.

[Sliver]

Not too many bike shops in dunners.. ride round to each of em.

What MCR do to you? I've only had good dealings with them..sometimes they are a bit short and sharp but they seem to be busy all the time.

Not that I spend much money with them.. bought some bearings and a camchain and an airfilter off em so far.. maybe few other bits n pieces. They don't hike the price up too much at least.

Ripped me real good on a job i should have done myself, and at first they said it would be 3 days and it took almost 2 months, and it was over 3 times what they "roughly" told me it was going to cost.

[Fast Eddie]

Ripped me real good on a job i should have done myself...

bummer..

shit happens

[Sliver]

bummer..

shit happens

Yeah lesson learnt...Lots of good bike shops anyway Kev at Motorextreme is great, the boys at vech are good and SPV (if he has a mechanic yet) are good, DN Moto to.