Who has the best selection of new handlebars for Dyna models in NZ?

[rocketman1]

Plenty in the USA but exchange rate and transport kill it for me.

[cynna]

im looking at getting some from burleighs in oz. road and sport are there agent here in nz

dont forget to add in the price of cables and brakeline if you are going higher

[cynna]

http://thehandlebarcompany.com/

and dont forget these guys in nelson

[rocketman1]

im looking at getting some from burleighs in oz. road and sport are there agent here in nz

dont forget to add in the price of cables and brakeline if you are going higher

Yeah, I love those burleigh bars, but they are expensive. very expensive almost twice the price of other bars.

[rocketman1]

http://thehandlebarcompany.com/

and dont forget these guys in nelson

Didnt know they existed.

[rocketman1]

The alternative is Fatboy bars, fitted them 2 years ago, best thing I did, comfy suit me just fine.
Fitting the internal wiring was a mission, no wonder the stores ask 700-$800 to fit them

[AllanB]

The alternative is Fatboy bars, fitted them 2 years ago, best thing I did, comfy suit me just fine.
Fitting the internal wiring was a mission, no wonder the stores ask 700-$800 to fit them

Can't see why a Harley is different to the old Honda I did decades back - run a feed wire first, tie it to the relevant control wires and carefully wiggle and pull it through. Fuck it - a HD will be easier as it has 1 inch bars, Hondas were smaller 7/8th.

[RDJ]

I raised and (had) rewired the '02 Dyna's bars a few years back. I had previously rewired the stock bars (for signal mirrors). I couldn't repeat the maneuver that Allan B suggested whether sober or sleepy, to get around the angles (2 in total). It was worth the shop's charges to get it done! And yes the longer cables were, in total, more than the bars cost.