Forum whore
I've got some kayaba USDs to go on the klr. One of the sliders has a few nicks and scratches, large enough to catch a fingernail. Besides sanding these smooth, is there any other way of reliably fixing these so they don't tear the seals? Obviously a new slider would be the best fix but would prefer not to go down that track.
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
Pootler
Fill the hole with epoxy then lightly sand off any high spots.
Originally Posted by Katman
Forum whore
fill with solder and then rub smooth...
Pootler
Does that work better than epoxy? Would look better I would have thought.
Forum whore
Will try the epoxy, assuming I can get it clean enough to stick. Looks are unimportant (its a KLR after all)
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
I am therefore I do
I heard that you apply a propane flame to the area to burn off any oil.....then epoxy it.
The Heart is the drum keeping time for everyone....
Obey the hosebeast
I've used araldite on road-going USD forks before. The fix worked well and wasn't particularly noticeable.
I used a carb cleaner type spray solvent to remove any oil from the area first.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks