For all of those that have an automated garge door opener, you may be interested in this little mod.
I've just hard wired my remote into the bike and it now it operates by either clicking onto high beams or flashing the high beam with the passing button.
It's a piece of cake to do, firstly your garge door remote needs to be of the 12 volt variety (the battery in it will tell you how many volts it is), if it's not you'll need to regulate the voltage to the correct level. Take the battery out of the remote. You need to make the button act as if it's always pushed so either short the switch out by soldering a wire across the terminals or tape the button down.
Then find the wire on the bike that is 12ish volts when the high beam is on and 0 volts when the high beams are off. Tap into this wire and solder it to the positive battery terminal on the remote, find a ground on the bike and run a wire from that to the negative terminal on the remote.
Then find a place under the fairing and attach the remote so it won't fall off.
And that's it, now you will be able to control your gargre door with your high beam switch!
Bookmarks